I EXT 2 DZ60 PROGR VT3

Controller with double microprocessor, configurable inputs and outputs
PWM for controlling small hydraulic systems.

It is a low-cost programmable controller specific for installations where few input/output resources are foreseen. Available with different hardware configurations, it allows you to solve many needs in a distributed CAN system, where versatility and simplicity of installation are essential.

Control system

- 2 8 Bit, 40 MHz Microprocessors

- Memoria RAM 2 Kb Master – 1 Kb Slave

- Memoria Flash 32 Kb Master – 16 Kb Slave

- 1 Kb Master EEPROM memory for storing parameters

Connectivity

- 1 CAN BUS line, CAN 2.0B (11 or 29 bit), compliant with ISO 11898-2, speed up to 1 Mbit/s

- Termination resistor (120 Ω) selectable via 2 pins

Electrical characteristics

- General power supply voltage: 8 ÷ 32 Vdc (Operates directly on the vehicle power supply network)

- Current consumption: 20mA ( @12V) 15mA (@24V)

- Maximum current: 10A

Mechanical and environmental characteristics

- Container: PA6

- Operating temperature range: -40°C to +80°C (-40°F to +176°F)

- Storage temperature range: -40°C to +85°C (-40°F to +185°F)

- Connector: 1 x 24 pole automotive

- Protection: IP65

-Controller of small on/off or proportional hydraulic systems
-Slave modules for CAN network signal collection
- Driving small/medium power electric motors
-Hydraulic control module for EN13849 systems (up to PL-C)
-Movement of nautical gangways
-Modulo slave per spreader